TH250 [69-UP] Automatic Transmission Bushing Output Shaft (Plastic) 86 250c

When the output shaft bushing in a TH250 or TH350 wears past its service limit, the shaft starts to move laterally inside the case, and that movement shows up as vibration, noise, and accelerated wear on everything around it. This listing is a single plastic output shaft bushing, part number, sized specifically for TH250 and TH350 automatic transmission units produced from 1969 through 1986.

The bushing is made from plastic rather than bronze. That matters on this application because a plastic bushing conforms to the shaft without scratching or galling the surface, which preserves the shaft for reuse. A bronze bushing that is even slightly misaligned during installation can score the shaft and turn a straightforward repair into a more expensive one.

This is a single piece, not a kit. It does not include any other rebuild components: no seals, no gaskets, no friction discs, no steels, no Automatic Transmission Filter, no band. If your job calls for a full rebuild you will need to source those parts separately. This listing covers only the output shaft bushing.

Each piece is pulled from stock and checked against the part record before it is packaged. A part list ships inside the box so you can confirm what you received matches what you ordered. REMCO has been working in automatic transmission parts since 1991, and that same verification step applies to every single piece that goes out, not just kits.

Before placing your order, pull the identification tag off the transmission case and confirm the code reads TH250 or TH350. Also confirm the unit was produced between 1969 and 1986. If the code or the year falls outside that range, this bushing is not the right fit for your application.

• A single plastic output shaft bushing sized for TH250 and TH350 units built from 1969 through 1986, covering the shaft support that wears over time and causes slop at the rear of the unit.
• This listing is for the output shaft bushing only. It does not include friction discs, steel plates, seals, gaskets, Automatic Transmission Filters, or any other rebuild components. Verify what your job needs before ordering.
• The plastic material on this bushing maintains a close fit against the output shaft without galling the shaft surface the way a worn or mismatched bushing does, helping the shaft run true inside the case.
• One plastic output shaft bushing for TH250 and TH350 applications. Article weight is 1 lb. Part number. Each piece is checked against the part record before it leaves the bench.
• Before ordering, confirm your transmission code is TH250 or TH350 and that the unit falls within the 1969 to 1986 production range. A wrong code means a wrong fit, so check the ID tag on the case first.

What's in the box

• 1 x Bushing, TH250 Output Shaft [Plastic] 86 250c 350 350c

Compatible vehicles

• Fits Regal [80-85], LeSabre [80-85], Electra [80-85], Estate Wagon [80-83], Century [80-81], Monte Carlo [80-84], Malibu [80-83], Impala [80-84], El Camino [80-84], Caprice [80-84], Camaro [81], Caballero [81-84], Delta 88 [80-85], Toronado [82-84], Nova [74-75], Camaro [74-75], Chevelle [74-75], Vega [74-77], Monza [75-79], Sunbird [76-79].