FIOD 4R70 4R75 [80-UP] Automatic Transmission Bushing Center Support E

For FIOD automatic transmissions. When the center support bushing in an FIOD or 4R70 automatic transmission wears down, shaft movement increases and the transmission begins to shift erratically or develop noise under load. This listing is for one center support bushing, SKU, selected specifically for that position in FIOD and 4R70 units built from 1980 onward.

The center support carries rotational load continuously while the transmission is in operation. A bushing that has lost its stock fit allows the shaft to move off its intended axis, which puts stress on clutch packs, thrust washers, and other surrounding components. Replacing the bushing at this location stops that chain of wear before it reaches more expensive parts.

This is a single piece, not a kit. It does not include any seals, gaskets, clutch friction discs, steel plates, Automatic Transmission Filter, or band. If your repair requires those components, they must be sourced separately. Review your disassembly notes or a parts diagram for the FIOD or 4R70 to confirm that the center support is the position that needs attention before placing your order.

At REMCO, operating in automatic transmission parts since 1991, each part is pulled and checked individually before it leaves. The box includes a parts list so you can verify what arrived matches what was ordered.

The bushing weighs 1 lb and is stocked under SKU. Confirm your unit is coded FIOD or 4R70 and that the center support bore is the worn location before ordering.

• FIOD automatic transmission: this center support bushing addresses wear at a critical load-bearing point inside the FIOD and 4R70, helping restore proper shaft alignment and reduce internal play.
• This listing covers one bushing only. It does not include any seals, gaskets, clutch discs, steels, Automatic Transmission Filter, or band. Verify the specific position you need before ordering.
• The center support position takes constant rotational stress, and a worn bushing here can cause erratic shifts and accelerated damage to surrounding components in FIOD and 4R70 units.
• One center support bushing, SKU, weighing 1 lb. Sized for the center support bore of FIOD and 4R70 automatic transmission units built from 1980 onward.
• Before ordering, confirm your unit code is FIOD or 4R70 and that the center support bushing is the exact position showing wear. A wrong position means a return.

What's in the box

• 1 x Bushing, Aod/fiod Center Support E 4r70 4R75

Compatible vehicles

• Fits Mustang [81-83], Thunderbird [82-89], Bronco [85-89], F250 3/4 Ton - Pickup [84-89], F350 1 Ton - Pickup [84-89], Mark VII [84-89], Town Car [81-89], Cougar [80-89], LTD [80-85], LTD Country Squire [83-89], LTD Crown Victoria [90-91], E100 1/2 Ton Econoline - Van [83].