TF-81SC [05-UP] Automatic Transmission Bushing Pump (1.850 ID)

When the pump bushing on a TF80-SC or TF-81SC wears out, oil film breaks down fast and bore damage follows, so getting the right replacement bushing with the correct geometry is the first step in a clean repair. This bushing is machined to a 1.850 in. inner diameter and includes oil pockets, which is the correct specification for the pump location on these units.

The oil pockets are not a cosmetic detail. They hold a thin film of fluid between the bushing and the shaft during operation. Without them, metal-to-metal contact starts immediately under load, and the pump bore can score before the fluid circuit even reaches full pressure. A plain bushing without pockets does not substitute here.

This is a single-piece listing. It does not include a seal kit, Automatic Transmission Filter, clutch discs, steels, or any other automatic transmission components. If you are doing a full overhaul, you will need to source those parts separately. Check your parts list against what you already have before ordering.

REMCO has been working in automatic transmission parts since 1991. Each piece is pulled, checked, and packed individually at the facility, not shipped from a pre-boxed lot. The box includes the part record so you can verify what you received against what was listed.

Before placing your order, confirm that your unit carries the TF80-SC or TF-81SC designation and that the build date falls within the 2005-and-up range. Application details on these transmissions can vary, and a few minutes of verification now avoids a return later.

• Oil pockets in the bushing help maintain film lubrication at the pump, reducing wear on the bore and extending the service life of surrounding components.
• This listing is for the pump bushing only. It does not include a rebuild kit, seals, clutch packs, Automatic Transmission Filter, or any other transmission parts. Review your parts list before ordering.
• The 1.850 in. inner diameter and integrated oil pockets are specific to the TF80-SC and TF-81SC pump assembly. Using a bushing without oil pockets in this location can lead to premature failure.
• One pump bushing, 1.850 in. ID, with oil pockets. Weighs 1 lb. Assembled and verified against its part record at the REMCO facility before shipping.
• Confirm your unit is a TF80-SC or TF-81SC and that it falls within the 2005-and-up application range before placing your order. Unit code and build date matter here.

What's in the box

• 1 x Bushing, TF-81SC Pump [1.850" Id][w Oil Pockets]

Compatible vehicles

• Fits Brera [05-09], 159 [06-10], Giulia [12-13], Spider [06-10], Regal [11-17], SRX [10-12], C4, C5, C6, C8 [10-12], DS4 [11-12], X-Type [10], Delta [10-12], Phedra [10-12], Thesis [10-12].